• Unique dual orifice design to eliminate air flow error

• Gasketed flange for ease of installation

• 1/4" brass hose barb connection for transducer/switch

• Available in 4" and 8" probe lengths

• 6061T-6 aluminium alloy

• Gasketed mounting flange, brass connector and mounting holes guarantee quick and easy installation

The A-520 Static Pressure Probe is designed to pick up static pressure in a duct, plenum, air handler or other HVAC equipment. The Probe has two orifices vertically opposite each other to cancel out any air flow induced errors. If a bent tube with a single orifice at the end is used to pick up static pressure in a duct, the air flowing across the probe may cause a small low pressure within the probe. This low pressure acts against the duct static pressure and hence induces an error which is exponentially proportional to the air flow. As the air flow increases, this error will increase also and as the flow decreases, the error decreases in an exponential relationship.

The engineers at MAMAC Systems resolved this problem with a unique design which incorporates two orifices diametrically opposing each other in a vertical plane. When the air flows across an orifice, it creates a suction towards that orifice. Similarly, when the same air flows across the other orifice, it creates an opposing suction which cancels out the first pressure drop. Regardless of the velocity, the flow error is constantly cancelled out and the A-520 provides an accurate, reliable reading.

The A-520 Static Pressure Probe is available in 6061T-6 aluminium alloy or 304 stainless steel material. In this way, for standard HVAC applications, the aluminium probe can be used. However, in exhaust applications where corrosive gases are present, the 304 stainless steel is recommended. The A-520 is available in two probe length options: 1) 4" aluminium/stainless steel; 2) 8" aluminium/stainless steel. The Probe is attached to a 2" O.D. flange with two conveniently located mounting holes for ease of attachment to the sheet metal. The flange also has a neoprene gasket to seal off the mounting holes. An industry standard 1/4" hose barb or 1/8" NPT female swivel brass fitting is provided for PVC/copper tubing connection. The A-520 is designed to substantially reduce the installation time required and to provide a convenient method to pick up static pressure in HVAC equipment.

Installation is completed by drilling a 1/4" hole in the sheet metal, inserting the Probe and securing the assembly by using the mounting flange as a template to mark and drill two holes for the self tapping sheet metal screws. A label is provided to correctly position the mounting holes during installation to insure that the two orifices are perpendicular to the air flow.

SPECIFICATIONS:

ORDERING INFORMATION: A-520